Remote wireless Flash Trigger RF-603 II Canon C3
-13%
Click Image for Gallery
Remote wireless Flash Trigger and shutter release RF-603 II for Canon C3
Transceiver can be set Off, or Transmit, or Receive.
Secure mounting ring for hotshoe
Increased synch speed .
Can trigger the radio-enabled YN560-III flashgun
Use:
1. As a Wireless Shutter Release
1).Has the function of Auto-Focus, Continuous shooting, Long Exposure, Half-Way Pressing, Full-way Pressing
2).Press the transmitter button.
3) Cords supplied for C3 cameras:
Canon EOS Digital SLR 1D 1D Mark II 1D Mark II N 1Ds 5D 7D 7D2 7DII 6D 1Ds Mark II 50D 40D 30D 20D 10D 5D2 5DII 5D3 5DIII
D30 D60 D2000 30D
EOS 250d
EOS R
EOS R5
EOS R3
EOS 6D Mark II
EOS 1Ds Mark III
EOS 6D Mark II
EOS 5D Mark IV
EOS D2000
EOS 1D Mark III
EOS 1D Mark IV
EOS 20Da
2. As a Wireless Flash Unit Trigger/receiver
1).Has the function of firing a flash speedlite.
Mount the transmitter on hot shoe of camera, connect the receiver with the flash speedlite, press shutter button half-way to wake up the flashgun at the same time, the green signal light will be blinking for seconds, and then full press shutter button.
2).One transmitter/receiver can trigger more than 2 receivers at the same time, so you can trigger more than 2 flashes at the same time.
.
3. As a Wireless Studio Flash Trigger
Using with a Studio Flash Sync Cable,
Type FSK 2.4GHz wireless remote system
Transmitter Distance 100M
Release Half-way press, Full-way Press
Like the RF-603, each unit is able to switch between acting as either a transmitter or receiver — there are no dedicated master or slave units. However the RF-603 II adds a toggle on the side with three positions: Off, TRX and TX. In TRX mode. The unit takes two AAA batteries.
Supplied with a tightening wheel and locking pin which should ensure the device stays put wherever you mount it.
Yongnuo has also increased the sync speed since the previous generation, raising it to 1/250–1/320 second,
Pack Contains:
2x tranceivers
1x shutter cable
1x manual
Transceiver can be set Off, or Transmit, or Receive.
Secure mounting ring for hotshoe
Increased synch speed .
Can trigger the radio-enabled YN560-III flashgun
Use:
1. As a Wireless Shutter Release
1).Has the function of Auto-Focus, Continuous shooting, Long Exposure, Half-Way Pressing, Full-way Pressing
2).Press the transmitter button.
3) Cords supplied for C3 cameras:
Canon EOS Digital SLR 1D 1D Mark II 1D Mark II N 1Ds 5D 7D 7D2 7DII 6D 1Ds Mark II 50D 40D 30D 20D 10D 5D2 5DII 5D3 5DIII
D30 D60 D2000 30D
EOS 250d
EOS R
EOS R5
EOS R3
EOS 6D Mark II
EOS 1Ds Mark III
EOS 6D Mark II
EOS 5D Mark IV
EOS D2000
EOS 1D Mark III
EOS 1D Mark IV
EOS 20Da
2. As a Wireless Flash Unit Trigger/receiver
1).Has the function of firing a flash speedlite.
Mount the transmitter on hot shoe of camera, connect the receiver with the flash speedlite, press shutter button half-way to wake up the flashgun at the same time, the green signal light will be blinking for seconds, and then full press shutter button.
2).One transmitter/receiver can trigger more than 2 receivers at the same time, so you can trigger more than 2 flashes at the same time.
.
3. As a Wireless Studio Flash Trigger
Using with a Studio Flash Sync Cable,
Type FSK 2.4GHz wireless remote system
Transmitter Distance 100M
Release Half-way press, Full-way Press
Like the RF-603, each unit is able to switch between acting as either a transmitter or receiver — there are no dedicated master or slave units. However the RF-603 II adds a toggle on the side with three positions: Off, TRX and TX. In TRX mode. The unit takes two AAA batteries.
Supplied with a tightening wheel and locking pin which should ensure the device stays put wherever you mount it.
Yongnuo has also increased the sync speed since the previous generation, raising it to 1/250–1/320 second,
Pack Contains:
2x tranceivers
1x shutter cable
1x manual